Gypsum tiles must be laid properly, as not only the aesthetic appearance of cosmetic facing, but also the service quality of the
substance will rely on the technology of work. The product is more also universal, and it can be attached to concrete, plaster,
brick or gypsum board sheets, provided that the top layer of the base is and has no defects.
If the defects of the foundation are important, it should be thoroughly treated with primer, then a cement mortar is made, which
matches all of the cracks. Subsequently the surface should be repeatedly primed and dried. In cases like this, its makeup should
decide on a special, comprising components which block the appearance of fungus and mold.
In today’s interior of these rooms most often used gypsum tiles, even imitating natural brick or stone. To perform cosmetic
finishing yourself, it’s essential firstly to choose a strategy of tile placement and prepare a remedy. It’s very important to pay
attention to the opposite side of the material. When its surface includes an embossed surface, then the adhesive should be placed
using an trowel, and if it is even, then using a top notch one.
The technologies of the job is as follows:
* A thin layer of glue is put on the pre-prepared wall. It is distributed over the foundation so that it is likely to place 4-5
tiles. Decorative cladding may be put either on plasterboard, also on putty.
* Glue the back side of the tiles with adhesive.
* Plaster components are pushed against the wall and their place is corrected. To align the seams, it is advised to use spacers.
* Finishing is carried out in rows, each of which should be changed by half a tile. Facing is completed to the corners of this
room, and then immediately eliminate any remaining mortar in the joints.
Drying the walls requires no longer than a day also takes a constant humidity and temperature inside the room. The final point in
the placing of gypsum tiles is their decoration. To get this done, the joints between the elements are full of a special solution,
the shade of which suits the brick.
Decorative imitation of brickwork around the walls is completed in the following manners:
* Cutting on the plastered surface of the seams of masonry with a bolt cutter with your hands;
* placing of tiles under the brick:
* mimicking the format and colour of the side surface of one brick;
* Imitating a fragment of brickwork of several bricks.
The very best way to decorate”under the brick” would be the one which permits you to create a practical coating together with the
most look of its resemblance to natural masonry. All three strategies to conduct this kind of finishing works fulfill the needs,
however, the cutting edge of joints with a bolt will be labor-intensive and the creation of considerable amounts of dust, and so
let us consider more typical ways.
The old finish is removed from the walls, and the outside, if necessary, is leveled to get rid of the need to paste plaster onto a
thick layer of adhesive.
Combining such cladding with different types of interior finishes can be both orderly and performed with no clear consistency,
chaotically, together with fake of indications of aging.
With the help of cosmetic gypsum tiles it’s possible to mimic a large number of textures.
A lot of textures can be imitated with the support of cosmetic gypsum tiles.
The wall where it’s to be installed must have the following characteristics:
masterfasada.ru * Hardness and durability of the surface;
* The lack of irregular locations and sharp sections;
* no more deformations.
Decorative tiles at the interior of the kitchen
Walls are made from a number of materials, let us break down the individual rules of setup.
When working with concrete, there’ll not be any huge problems. It’s only necessary to take into consideration the porosity of the
material. Concrete, which has practically no pronounced pores, should be treated with a great primer.
Mounting gypsum tiles concrete
Before beginning work on the setup of gypsum tiles on the walls, then it’s well worth assessing the strength of this surface. When
the plaster does not fall off the walls and at precisely the identical time holds well, you can simply paint it using primer.
Mount the tiles on the painted concrete should not. The surface ought to be scratched, ensuring to misfire, then it should be
grouted and coated with a layer of plaster.